To Set Up A Point-To-Point Connection Without An Emulation Module - Agilent Technologies E5900B User Manual

Connecting the Emulation Probe to a LAN
Setting up a Point-to-Point Connection
To set up a point-to-point connection without an
emulation module
1 Connect the crossover LAN cable between the logic analysis system
and the emulation probe.
2 Turn on power to the emulation probe.
3 In the logic analysis system main window, select the System
Administration icon.
4 Select Network Setup....
5 Select Standard to turn on networking.
6 Select Default Network.
Leave the network parameters with the default values. The IP address should
be 192.0.2.231.
7 In the Network Setup dialog, select OK.
8 In the main system window, select the Workspace icon.
9 Drag the emulation probe icon onto the workspace.
10 From the emulation probe icon, select Init Probe LAN Addresses....
11 Enter the link-level address of the emulation probe.
The link-level address (LLA) is printed on a label above the LAN connector on
the emulation probe.
12 Enter the following IP address: 192.0.2.233
13 Select OK then follow the instructions.
Note about the Setup Assistant: If networking is disabled for the 16700-series
logic analysis system, the Setup Assistant will guide you through the process
of setting up a point-to-point connection. If networking is enabled, the Setup
Assistant assumes you want to connect the emulation probe to a site LAN.
38 Emulation for the Motorola M•CORE