Table of Contents
Advertisement
CAUTION:
See Also
Setting up Debugger Software
The instructions in this manual assume that your PC or workstation is already
connected to the LAN, and that you have already installed the debugger
software according to the debugger vendor's documentation.
To use your debugger with the emulation probe, follow these general steps:
• Connect the emulation probe to the LAN (see page 25).
• Connect the emulation probe to your target system (see "Connecting the
Emulation Probe to Your Target System" on page 57).
• If you are using a logic analysis system, export the logic analysis system's
display to your PC or workstation (see "To export the logic analysis
system's display to a workstation" on page 82).
• Configure the emulation probe (see "Configuring the Emulation Probe" on
page 63).
• Begin using your debugger.
If you use the Emulation Control Interface to configure the emulation probe,
remember to end the Emulation Control Interface session before you start the
debugger.
Do not use the Emulation Control Interface at the same time as a debugger.
The Emulation Control Interface and debuggers do not keep track of
commands issued by other tools. If you use both at the same time, the tools
may display incorrect information about the state of the processor, possibly
resulting in lost data.
Refer to the documentation for your debugger for more information on
connecting the debugger to the emulation probe.
To export the logic analysis system's display to a web
browser
You can export the display of an Agilent 16700-series logic analysis system to
your PC or workstation using a web browser. See the online help in your logic
analysis system for more information.
Emulation for the Motorola M•CORE
Using the Emulation Probe
Setting up Debugger Software
81
Advertisement
Table of Contents
Troubleshooting
