Agilent Technologies E5900B User Manual page 58

Connecting the Emulation Probe to Your Target System
This chapter shows you how to connect the emulation probe to the target
system and how to configure the emulation probe and target.
Here is a summary of the steps for connecting and configuring the emulation
probe:
1 Make sure the target system is designed to work properly with the
emulation probe. (See page 53.)
2 Install the emulation module in your logic analysis system, if necessary.
(See page 43.)
3 Connect the emulation probe to a LAN. (See page 25.)
4 Connect the emulation probe to your target system using the ribbon
cable. (See page 59.)
5 Update the firmware of the emulation probe, if necessary.
(See page 103.)
6 Configure the emulation probe. (See page 63.)
7 Connect a debugger to the emulation probe, if applicable.
(See page 79.)
58 Emulation for the Motorola M•CORE