Step 4: Check The Emulation Module; If You Have Problems Using The Emulation Probe As An Emulation Module In A 16700-Series Logic Analysis System - Agilent Technologies E5900B User Manual

Step 4: Check the emulation module

If you are using an E5901B emulation module, select the emulation module
icon and start the Emulation Control Interface.
If you have problems using the emulation probe
as an emulation module in a 16700-series logic
analysis system
To use the emulation probe as an emulation module in a 16700-series logic
analysis system you must have installed an E5901B emulation module and you
must connect the emulation probe to the emulation module using the module/
probe interconnect cable. In addition, the emulation probe must be connected
to the logic analysis system using a LAN.
• Check that the emulation probe and the logic analysis system are on
the LAN.
If you are using a site LAN you should be able to ping both the logic analysis
system and the emulation probe.
If you are using a point-to-point LAN connection you must use a special
crossover LAN cable, such as the one supplied with the emulation module.
The telnet window of the logic analysis system should be able to communicate
with the emulation probe. This window can be found by selecting the "System
Admin" icon in the main system window.
• Check that the emulation probe is connected to the emulation module
with the module/probe interconnect cable.
If this cable is connected, you should be able to display the firmware version
from the "Update Firmware" window.
• Check that you have the proper processor support package installed.
You can check this by selecting the System Admin icon in the main system
window, then looking at the list of software packages installed.
• Test the emulation module. See page 150.
• Test the emulation probe. See page 151.
• Try using the Setup Assistant to configure your measurement setup.
Emulation for the Motorola M•CORE
Troubleshooting the Emulation Probe
General Troubleshooting
127