Agilent Technologies E5900B User Manual page 160

Glossary
raise a probe above a target
microprocessor to avoid mechanical
contact with other components
installed close to the target
microprocessor. Sometimes called a
"connector board."
Flexible Adapter Two connection
devices coupled with a flexible cable.
Used for connecting probing
hardware on the target
microprocessor to the analysis probe.
Gateway Address An IP address
entered in integer dot notation. The
default gateway address is 0.0.0.0,
which allows all connections on the
local network or subnet. If
connections are to be made across
networks or subnets, this address
must be set to the address of the
gateway machine.
General-Purpose Flexible
Adapter A cable assembly that
connects the signals from an
elastomeric probe adapter to an
analysis probe. Normally, a male-to-
male header or transition board
makes the connections from the
general-purpose flexible adapter to
the analysis probe.
High-Density Adapter Cable A
cable assembly that delivers signals
from an analysis probe hardware
interface to the logic analyzer pod
160
cables. A high-density adapter cable
has a single MICTOR connector that
is installed into the analysis probe,
and two cables that are connected to
corresponding odd and even logic
analyzer pod cables.
High-Density Termination
Adapter Cable Same as a High-
Density Adapter Cable, except it has
a termination in the MICTOR
connector.
In Background, In Monitor See
Background Debug Monitor.
Inverse Assembler Software that
displays captured bus activity as
assembly language mnemonics. In
addition, inverse assemblers may
show execution history or decode
control busses.
IP address Also called Internet
Protocol address or Internet address.
A 32-bit network address. It is usually
represented as decimal numbers
separated by periods; for example,
192.35.12.6.
Jumper Moveable direct electrical
connection between two points.
JTAG (OnCE) port See debug
port.
Label Labels are used to group and
Emulation for the Motorola M•CORE