To Connect The Emulation Probe To The Target System - Agilent Technologies E5900B User Manual

To connect the emulation probe to the target
system
The emulation probe can be connected to a target system through a 14-pin
JTAG port connector (a 14-pin male 2x7 header connector on the target
system).
The emulation probe should be connected to the target system using the
ribbon cable provided.
1 Turn off power to the target system.
2 Turn off power to the emulation probe.
3 Plug the un-keyed end (pin 8 is open) of the ribbon cable into the
emulation probe.
Emulation for the Motorola M•CORE
Connecting the Emulation Probe to Your Target System

To connect the emulation probe to the target system

59