Connecting The Appliance To Network Printers; Setting Up The Utm-1 Appliance - Check Point UTM-1 Edge User Manual

Internet security appliance
Hide thumbs Also See for UTM-1 Edge:
Table of Contents

Advertisement

Connecting the Appliance to Network Printers

In models with a print server, you can connect network printers.
To connect network printers
Connect one end of a USB cable to one of the appliance's USB ports.
1.
If needed, you can use the provided USB extension cord.
2.
Connect the other end to a printer or a USB 2.0 hub.
Warning: Verify that the USB devices' power requirement does not exceed the
appliance's USB power supply capabilities. Failure to observe this warning may
cause damage to the appliance and void the warranty.
For information on setting up network printers, see Setting up Network Printers on page
630.

Setting Up the UTM-1 Appliance

After you have installed the UTM-1 appliance, you must set it up using the steps shown
below.
When setting up your UTM-1 appliance for the first time after installation, these steps
follow each other automatically. After you have logged on and set up your password, the
UTM-1 Setup Wizard automatically opens and displays the dialog boxes for performing
the initial configuration of the router. If desired, you can exit the Setup Wizard and
perform each of these steps separately.
Chapter 3: Installing and Setting Up UTM-1

Connecting the Appliance to Network Printers

83

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the UTM-1 Edge and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents

Save PDF