Check Point UTM-1 Edge User Manual page 517

In this field... Do this...
Subnet mask Select the subnet masks for the destination network addresses.
Note: Obtain the destination networks and subnet masks from the VPN
site's system administrator.
Table 103: Authentication Methods Fields
In this field... Do this...
Username and Select this option to use a user name and password for VPN
Password authentication.
In the next step, you can specify whether you want to log on to the VPN
site automatically or manually.
Certificate Select this option to use a certificate for VPN authentication.
If you select this option, a certificate must have been installed. (Refer to
Installing a Certificate on page 528 for more information about
certificates and instructions on how to install a certificate.)
RSA SecurID Select this option to use an RSA SecurID token for VPN authentication.
Token
When authenticating to the VPN site, you must enter a four-digit PIN code
and the SecurID passcode shown in your SecurID token's display. The
RSA SecurID token generates a new passcode every minute.
SecurID is only supported in Remote Access manual login mode.
Chapter 16: Working with VPNs
Adding and Editing VPN Sites
503