Controlling The Appliance Via The Command Line - Check Point UTM-1 Edge User Manual

Controlling the Appliance via the Command Line

In this field...
Syslog Port
Default

Controlling the Appliance via the Command Line

Depending on your UTM-1 model, you can control your appliance via the command line in
the following ways:
•
Using the UTM-1 Portal's command line interface.
See Using the UTM-1 Portal on page 587.
•
Using a console connected to the UTM-1 appliance.
For information, see Using the Serial Console on page 589.
•
Using an SSH client.
See Configuring SSH on page 595.
586
Do this...
Type the port number of the Syslog server.
Click to reset the Syslog Port field to the default (port 514 UDP).
Check Point UTM-1 Edge User Guide