Check Point UTM-1 Edge User Manual page 570

Using RADIUS Authentication
5. If desired, configure user permissions and/or the HotSpot session timeout on
the RADIUS server.
See Configuring RADIUS Attributes on page 560.
Table 115: RADIUS Page Fields
In this field...
Primary/Secondary
RADIUS Server
Address
Port
Shared Secret
556
Do this...
Configure the primary and secondary RADIUS servers.
By default, the UTM-1 appliance sends a request to the primary
RADIUS server first. If the primary RADIUS server does not respond
after three attempts, the UTM-1 appliance will send the request to the
secondary RADIUS server.
Type the IP address of the computer that will run the RADIUS service
(one of your network computers) or click the corresponding This
Computer button to allow your computer to host the service.
To clear the text box, click Clear.
Type the port number on the RADIUS server's host computer.
The default port number is 1812.
Type the shared secret to use for secure communication with the
RADIUS server.
Check Point UTM-1 Edge User Guide