Check Point UTM-1 Edge User Manual page 605

The Port Setup page appears.
In the Assign to drop-down list, select Console.
4.
In the Port Speed drop-down list, select the Serial port's speed (in bits per
5.
second).
The Serial port's speed must match that of the attached serial console. The default
value is 57600.
Click Apply.
6.
You can now control the UTM-1 appliance from the serial console.
For information on all supported commands, refer to the Embedded NGX CLI
Reference Guide.
Chapter 19: Maintenance
Controlling the Appliance via the Command Line
591