Check Point UTM-1 Edge User Manual page 327

from accessing the Internet through the UTM-1 appliance, the reason why it was
blocked is shown in red.
If a network is bridged, the bridge's name appears in parentheses next to the network's
name.
If you are exceeding the maximum number of computers allowed by your license, a
warning message appears, and the computers over the node limit are marked in red.
These computers are still protected, but they are blocked from accessing the Internet
through the UTM-1 appliance.
Note: Computers that did not communicate through the firewall are not counted for
node limit purposes, even though they are protected by the firewall and appear in
the My Computers table.
Note: To increase the number of computers allowed by your license, you can
upgrade your product. For further information, see Upgrading Your Software
Product on page 582.
If Secure HotSpot is enabled for some networks, each computer's HotSpot status is
displayed next to it. The possible statuses include:
•
Authenticated. The computer is logged on to My HotSpot.
•
Not Authenticated. The computer is not logged on to My HotSpot.
•
Excluded from HotSpot. The computer is in an IP address range excluded from
HotSpot enforcement. To enforce HotSpot, you must edit the network object.
See Adding and Editing Network Objects on page 189.
If Remote Desktop is enabled, a link appears next to each computer, enabling you to
access its desktop remotely. For information on using Remote Desktop, see Using
Remote Desktop on page 565.
Next to each computer, an Add button enables you to add a network object for the
computer, or an Edit button enables you to edit an existing network object for the
computer. For information on adding and editing network objects, see Adding and
Editing Network Objects on page 189.
To refresh the display, click Refresh.
2.
3. To view node limit information, do the following:
Click Node Limit.
a.
Chapter 11: Viewing Reports
Viewing Computers
313