HP 8924C Reference Manual page 93

Call Control Screens - ANALOG MEAS
Figure 9 The ANALOG MEAS Screen
This screen is used to make RF and audio measurements on the mobile station
connected to the Test Set while on an active voice channel.
The Test Set does not monitor the mobile station's transmitted carrier power while
the ANALOG MEAS screen is displayed. If the power falls below 0.0005 Watts
no error message is displayed nor will the Test Set terminate the call while on the
ANALOG MEAS screen.
Requirements for Using The ANALOG MEAS Screen
The Test Set must be in the connected state (that is, the
lit) in order to use the ANALOG MEAS screen.
The mobile station's speaker output must be connected to the Test Set's AUDIO
IN connector and the mobile station's microphone input must be connected to the
Test Set's AUDIO OUT connector in order to use the ANALOG MEAS screen. If
the mobile station does not have audio connections the ANALOG MEAS screen
cannot be used.
S:\hp8924c\REFGUIDE\MANUAL\screens.chp
Chapter 3, Description of Screens
Call Control Screens
annunciator is
Connect
93