HP 8924C Reference Manual page 407

SSD Update
An SSD update can be performed on the paging/access channels or on the traffic
NOTE:
channel.
When
SSD Update Execute
mobile station, and the
SSD Update
Update Message, the mobile sends back a Base Station Challenge Order.
If the Test Set does not receive the Base Station Challenge Order from the mobile
within 20 seconds, the Test Set will beep and the following message will be
displayed:
No response from mobile to SSD Update request
annunciator will be turned off.
SSD Update
If the Test Set receives the Base Station Challenge Order, it sends a Base Station
Challenge Confirmation Order to the mobile station. This order includes the 18-
bit parameter, AUTHBS. After determining whether AUTHBS sent from the Test
Set matches its computed value, the mobile station sends an SSD Update
Confirmation (or Rejection) Order to the Test Set, and a message indicating the
Pass/Fail status is displayed. The
off.
If the SSD_A=0 annunciator was lit before the SSD Update was executed, it will
be turned off.
HP-IB Example
"CDMA:AUTH:SSD"
initiates the SSD Update procedure.
Operating Considerations
A successful SSD Update requires the mobile station's A-Key to be entered in the
A-Key field. The mobile station's ESN must also be entered in the
field. If a valid ESN is not found, the Test Set will beep and display the following
message:
Cannot perform SSD Update until the phone has
.
registered
See Also
Authentication Tests, HP 8924C Application Guide
Screens Where Field is Present
CDMA AUTHENTICATION
S:\hp8924c\REFGUIDE\MANUAL\fields.chp
Chapter 4, Description of Fields
Fields That Begin with the Letter S
is selected, an SSD Update Message is sent to the
annunciator is lit. In response to the SSD
annunciator will then be turned
SSD Update
, and the
MS Database
407