HP 8924C Reference Manual page 48

Chapter 1, Description of Keys
Keys That Begin with the Letter R
NOTE: When setting a measurement reference point, any non–attribute unit's unit-of-measure must
be specified in the command string, otherwise the current attribute unit is assumed by the Test
Set. Refer to
Overview
48
Syntax
:REFerence:STATe <ON> or <1>
:REFerence:STATe <OFF> or <0>
Example
OUTPUT 714;"MEAS:RFR:POW:REF:STAT ON"
This turns the measurement reference point for the TX power measurement
ON.
To Query the State of Measurement Reference Points.
:REFerence:STATe? commands to query the state of a measurement reference
point. The query returns a 1 if a measurement reference points is ON, and a 0 if a
measurement reference points is OFF.
Syntax
:REFerence:STATe?
Example
OUTPUT 714;"MEAS:RFR:POW:REF:STAT?"
ENTER 714;Meter_on_off ! returns a 1 (ON) or 0 (OFF)
This queries the state of the measurement reference point for the TX power
measurement.
To Set A Measurement Reference Point.
to set a measurement reference point.
Syntax
:REFerence:VALue <real number>
Example
OUTPUT 714;"MEAS:RFR:POW:REF:VAL 20"
This sets the measurement reference point for the TX power measurement to
20 watts.
"To Specify Units-of-Measure for HP-IB Data Transfer"
chapter of
the HP 8924C User's Guide.
To Query A Measurement Reference Point.
commands to query a measurement reference point.
Syntax
:REFerence:VALue?
Example
OUTPUT 714;"MEAS:RFR:POW:REF:VAL?"
ENTER 714;Ref_val
This queries the measurement reference point for the TX power measurement.
Use the
Use the :REFerence:VALue commands
Use the :REFerence:VALue?
S:\hp8924c\REFGUIDE\MANUAL\keys.chp
the
in Operating