HP 8924C Reference Manual page 167

Answer Mode
Antenna In
This field determines whether the Test Set will require answering before
conversation or exchange of other traffic can begin. Use of this field applies only
to mobile station originated calls
a mobile station originated call will automatically progress to the
• Auto -
connected state. No ringback tone will be heard on the mobile station's handset.
- the ANS key must be pressed to remove the ringback tone from the
•
Manual
mobile station's audio path and allow user conversation, or other traffic, to be
sent.
HP-IB Example
"DISP CCON;CDMA:CALL:ANSWer:MODE 'MANUAL'"
selects manual mode.
"DISP CCON;CDMA:CALL:ANSWer"
answers a mobile station originated call.
Operating Considerations
Calls will connect faster when
Screens Where Field is Present
CDMA CELL SITE CONFIGURATION
This field is used to indicate losses or gains between the ANT IN port and the
device-under-test.
Enter a positive value to indicate a gain (such as an amplifier). The Spectrum
Analyzer's marker level (
amount. The Spectrum Analyzer's
same amount, so the trace position does not appear to change.
Enter a negative value to indicate a loss (such as cable loss). The Spectrum
Analyzer Marker's Level (
amount. The Spectrum Analyzer's
same amount, so the trace position does not appear to change.
This field is only used when the
See Also
"RF Level Offset" on page 367
Screens Where Field is Present
CONFIGURE
S:\hp8924c\REFGUIDE\MANUAL\fields.chp
Fields That Begin with the Letter A
is set to
Answer Mode
) measurement is automatically reduced by that
Lvl
is automatically decreased by the
Ref Level
) measurement is automatically increased by that
Lvl
is automatically increased by the
Ref Level
RF Level Offset
Chapter 4, Description of Fields
.
Auto
field is set to .
On
167