HP 8924C Reference Manual page 430

Chapter 4, Description of Fields
Fields That Begin with the Letter T
Traffic Data Mode
430
This field selects the desired service option. "Rate set 2" refers to vocoders that
operate at 14.4 kips full rate.
- normal traffic
•
Svc Opt 1
- data loopback
•
Svc Opt 2
- service redirection
•
Svc Opt 3
• Svc Opt 6 - short message service (for rate set 1)
- data loopback (for rate set 2 vocoders, displayed when the
•
Svc Opt 9
Protocol field is set to TSB-74 or J-STD-008)
• Svc Opt 14 - short message service (for rate set 2)
- normal traffic (for rate set 2 vocoders, displayed when the
•
Svc Opt 32768
Protocol field is set to TSB-74 or J-STD-008)
HP-IB Example
"DISP CCNT;CDMA:CALL:TRAFfic:DATA:MODE 'SVC OPT 1'"
selects service option 1.
Operating Considerations
Data loopback is used during most mobile station tests.
The desired service option can be selected at any time. If a service option change
is attempted while a call is connected, and the mobile station does not respond to
the message, a beep will sound and the service option will not change.
This field is duplicated on the CDMA CELLULAR MOBILE TRANSMITTER
TEST, CDMA CALL CONTROL, CDMA CELLULAR MOBILE RECEIVER
TEST, CDMA AUTHENTICATION, and CDMA SHORT MESSAGE
SERVICE screens.
Screens Where Field is Present
CDMA CALL CONTROL
CDMA TRANSMITTER POWER RANGE TEST
CDMA CELLULAR MOBILE RECEIVER TEST
CDMA CELLULAR MOBILE TRANSMITTER TEST
CDMA SHORT MESSAGE SERVICE
CDMA AUTHENTICATION
S:\hp8924c\REFGUIDE\MANUAL\fields.chp