HP 8924C Reference Manual page 280
Cdma mobile station test set
Hide thumbs
Also See for 8924C:
- User manual (350 pages) ,
- Application manual (359 pages) ,
- Assembly (640 pages)
Table of Contents
Advertisement
Chapter 4, Description of Fields
Fields That Begin with the Letter I
Intensity
Internal
280
This field adjusts the screen intensity from a setting of 1 (very dim) to 8 (bright).
If the setting is set too low, the screen can no longer be read. If you can't read the
screen, and you don't know where the cursor is (or even what screen is displayed),
press PRESET, and re-access the CONFIGURE screen. The cursor automatically
goes to this field at that point. Press 8, ENTER to set the maximum intensity, and
re-adjust if desired.
This setting is retained when the instrument is turned off.
Screens Where Field is Present
CONFIGURE
This field selects the trigger source.
•
Internal uses the signal being displayed for triggering.
•
External uses the rear-panel EXT SCOPE TRIGGER INPUT for triggering. This is
a TTL level trigger (approximately 2.5 V).
•
ENCODER uses the signaling encoder for triggering. The encoder must be sending its
signal to trigger the oscilloscope.
Screens Where Field is Present
OSCILLOSCOPE
S:\hp8924c\REFGUIDE\MANUAL\fields.chp
Advertisement
Table of Contents
