HP 8924C Reference Manual page 434

Chapter 4, Description of Fields
Fields That Begin with the Letter T
Tune Mode
434
This field is displayed on the screens listed below when the RF Display field on
the CONFIGURE screen is set to "Freq".
This field selects Automatic or Manual tuning of the RF Analyzer.
tuning causes the RF Analyzer to find the signal with the greatest amplitude
Auto
>-36 dBm, and to set the Tune Frequency for that signal.
tuning requires the operator to set the Tune Frequency for the RF signal
Manual
to be analyzed.
Operating Considerations
Changing the
Tune Mode
tuning enables the
TX Frequency
measurement.
TX Freq Error
After autotuning to the desired signal, select
from changing when the signal is no longer applied.
Tune Freq
Screens Where Field is Present
ADJACENT CHANNEL POWER
DUPLEX TEST
RF ANALYZER
TX TEST
also changes the RF frequency display. Automatic
measurement. Manual tuning enables the
Manual
tuning to prevent the
S:\hp8924c\REFGUIDE\MANUAL\fields.chp