HP 8924C Reference Manual page 330

Chapter 4, Description of Fields
Fields That Begin with the Letter P
PCS Intrfc Control
NOTE: Settings to this field cannot be saved to or recalled from a Save/Recall register.
Phone Num:
CAUTION: Do not confuse the Phone Num: field, which is displayed in the upper right-hand portion of
the CALL CONTROL screen, with the Phone Num selection of the MS Id field.
NOTE: An all zero MIN number (000000000), which does not represent a valid phone number, will
convert to the following phone number: 111111?111.
330
This field allows you to establish serial communication between the Test Set and
an HP 83236B PCS Interface.
HP-IB Example
"CONF:PCSMode 'On'"
configures the Test Set to establish serial communication with a PCS Interface.
Operating Considerations
Power to the Test Set must be cycled after changes to this field. The HP 83236
PCS Interface must be configured correctly, connected to the Test Set as shown in
the HP 83236B User's Guide, and power must be turned on.
Screens Where Field is Present
CONFIGURE
This field displays the decoded MIN number received from the mobile station on
the reverse control channel in response to a forward control channel message. The
field is displayed only when the
Phone Num:
reverse control channel message containing this information has been decoded.
Refer to the
"Display" field on page 223
measurement results from this field.
Screens Where Field is Present
CALL CONTROL
field is set to
Display
for information on how to read
S:\hp8924c\REFGUIDE\MANUAL\fields.chp
and a
Data