TX Freq Error
TX Freq Error
The
field is displayed only when the
TX Freq Error
. A numeric value would only be displayed in the connected state (that is, the
Meas
annunciator is lit).
Connect
This field displays the frequency error (error = assigned carrier frequency -
measured carrier frequency) of the carrier being transmitted by the mobile station.
Four dashes (----) indicates that there is no carrier frequency present to measure.
See
"Measure"
in the HP-IB Command Syntax chapter of the HP 8924C
Condensed Programming Reference Guide for programming command syntax.
Refer to the
"Display" field on page 223
measurement results from this field.
Screens Where Field is Present
CALL CONTROL
This measurement area is used to display transmitter frequency error . This type of
measurement displayed depends on the
DUPLEX TEST, or RF ANALYZER screen being set to
See Also
Tune Mode field description, on page 434
Screens Where Field is Present
ADJACENT CHANNEL POWER
ANALOG MEAS
DUPLEX TEST
RF GENERATOR
AF ANALYZER
RF ANALYZER
TX TEST
S:\hp8924c\REFGUIDE\MANUAL\fields.chp
Chapter 4, Description of Fields
Fields That Begin with the Letter T
Display
for information on how to read
setting in the TX TEST,
Tune Mode
Manual.
field is set to
435