Figure 4-7: Sdc10 Fixings To Angled Bracket; Figure 4-8: Removing The Rear Enclosure Fixings; Table 4.10: Analogue Output Dip Switch Settings - Teledyne 440 System Manual

4 – Electrical Installation

Figure 4-7: SDC10 fixings to angled bracket

3. Carefully remove the Panel PC from the angled brackets. Be careful not to damage the cables
assemblies attaching the Comms Enclosure to the Panel PC. These cables should not be dis-
connected during this procedure.
4. Remove the 4 x fixings attaching the rear enclosure to the Panel PC.

Figure 4-8: Removing the rear enclosure fixings

5. Carefully remove the comms enclosure from the fixing bracket. Ensure the cables connected
to the underside of the enclosure are not damaged.
6. Table 4.10 outlines the function of each the DIP switches. Configure the switches to meet
installation requirements.

Table 4.10: Analogue output DIP switch settings

Switch
SW1
4-18
Function State
OFF
CH1 gain
ON
© Teledyne TSS
Output
CH1 2V/m
CH1 1V/m
DPN 402196 Issue 4.1