Table of Contents
Advertisement
SP-F-SIM
Flame Simulators
USER MANUAL
5.2 Battery replacement
Battery replacement in a safe area– Battery chamber should only be opened in a non-
hazardous location
1. Release the locking screw using the Allen key.
2. Using strap wrench tool to remove the back-battery cover (2) of simulator by unscrewing.
3. Disconnect the battery connector from the PCB.
4. Remove the Battery by pulling it out from the holder.
5. Put a new Battery in place and connect the connector.
6. Connect supplied charger to charging jack (8) and connect charger to power supply, 110-
220VAC.
7. Allow to charge for at least 3 hours.
8. Disconnect charger, close back-battery cover (2) and tighten using the removal tool.
9. Close the locking screw using the Allen key.
16
SP-F-SIM-EN
Revision 1.0
Advertisement
Table of Contents
