Table of Contents
Advertisement
Installing the 4 LFF display port/USB module
Prerequisites
Before installing this option, be sure you have the following:
•
The components included with the hardware option kit
•
T-10 Torx screwdriver
Procedure
1.
Power down the server (Power down the server on page 31).
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3.
Do one of the following:
a. Extend the server from the rack (Extend the server from the rack on page 31).
b. Remove the server from the rack (Remove the server from the rack on page 32).
4.
Remove the access panel (Remove the access panel on page 32).
5.
Using a Torx T-10 screwdriver, remove the 4 LFF display port/USB blank.
Hardware options installation
123
Advertisement
Table of Contents
