HPE ProLiant DX360 Gen10 User Manual page 138

WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
2. Update the system ROM.
Locate and download the latest ROM version from the Hewlett Packard Enterprise Support Center website.
Follow the instructions on the website to update the system ROM.
3. Power down the server (Power down the server on page 31).
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5.
Do one of the following:
Extend the server from the rack (Extend the server from the rack on page 31).
•
Remove the server from the rack (Remove the server from the rack on page 32).
•
6.
Place the server on a flat, level work surface.
7. Remove the access panel (Remove the access panel on page 32).
8. If needed, remove any expansion boards installed in slot 3.
9. Remove the primary PCI riser cage (Remove the primary PCI riser cage on page 34).
10. Proceed to Installing the TPM board and cover on page 138.
Installing the TPM board and cover
Procedure
1. Observe the following alerts:
138 Hardware options installation