Table of Contents
Advertisement
8.
Install one of the following, as needed:
Expansion boards (Installing an expansion board in the secondary riser cage on page 95)
•
•
Controllers (Controller options on page 100)
9.
Install the access panel (Install the access panel on page 32).
10. Install the server into the rack (Installing the server into the rack on page 45).
11. Connect each power cord to the server.
12. Connect each power cord to the power source.
13. Power up the server (Power up the server on page 31).
Installing an expansion board in the secondary riser cage
Prerequisites
Before installing this option, be sure that you have the following:
•
The components included with the hardware option kit
•
T-10 Torx screwdriver
Procedure
1.
Observe the following alerts:
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server before beginning any
installation procedure. Improper grounding can cause electrostatic discharge.
2.
Back up all server data.
Hardware options installation
95
Advertisement
Table of Contents
