Table of Contents
Advertisement
13. Connect all necessary internal cabling to the expansion board. For more information on these cabling
requirements, see the documentation that ships with the option.
14. Install the drive cage assembly.
15. Connect all cables to the drive backplane.
16. Install the air baffle.
If the 4:1 riser signal cable or Smart Storage Battery are installed in the air baffle, reconnect the cables to
the risers. For more information, see "Installing the air baffle."
17. Install the access panel.
18. Install the server into the chassis.
19. Connect all peripheral cables to the server .
20. Power up the server .
Dedicated iLO management port module option
Rules and limitations for installing the dedicated iLO management port
module
Observe the following rules and limitations when installing an dedicated iLO management port module:
•
If a dedicated iLO management port module is installed in the server:
◦
The server can only connect to a network through the dedicated iLO management port module.
◦
The server cannot be accessed through the chassis management module.
•
If using the chassis management module iLO ports or the dedicated iLO management port module to
connect to a network, the network must operate at a speed of 1 Gb/s. The server cannot connect to the
network if the network is operating at a speed of 10/100 Mb/s or 10 Gb/s.
For more information about product features, specifications, options, configurations, and compatibility, see the
product QuickSpecs on the Hewlett Packard Enterprise website.
Installing a dedicated iLO management port module
About this task
For more information about product features, specifications, options, configurations, and compatibility, see the
product QuickSpecs on the Hewlett Packard Enterprise website.
104
Dedicated iLO management port module option
Hide quick links:
Advertisement
Table of Contents
