Table of Contents
Advertisement
Expansion boards (Installing an expansion board in the primary riser cage on page 87)
•
GPU (Installing an accelerator or GPU in the primary riser cage)
•
•
Controllers (Controller options on page 100)
11. Install the riser cage (Install the primary PCI riser cage on page 35).
12. Install the access panel (Install the access panel on page 32).
13. Install the server in the rack.
14. Connect each power cord to the server.
15. Connect each power cord to the power source.
16. Power up the server (Power up the server on page 31).
Installing the SATA M.2 2280 riser option
Prerequisites
Before installing this option, be sure that you have the following:
•
The components included with the hardware option kit
•
Up to two 2280 form factor M.2 drives
•
T-15 Torx screwdriver
Procedure
1.
Power down the server (Power down the server on page 31).
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3.
Do one of the following:
a. Extend the server from the rack (Extend the server from the rack on page 31).
b. Remove the server from the rack (Remove the server from the rack on page 32).
4.
Remove the access panel (Remove the access panel on page 32).
5.
Remove the primary PCI riser cage (Remove the primary PCI riser cage on page 34).
6.
If needed, remove any expansion boards installed in the riser cage.
Hardware options installation
85
Advertisement
Table of Contents
