8.
Install high-performance fans in each of the seven fan bays.
If needed, ensure each fan is securely installed by pressing the tab. Do not press on other areas of the fan.
9.
Install the access panel (Install the access panel on page 32).
10. Slide the server into the rack.
11. Connect each power cord to the server.
12. Connect each power cord to the power source.
13. Power up the server (Power up the server on page 31).
Drive options
Depending on the configuration, this server supports SAS, SATA, NVMe, and uFF M.2 drives. For more information on
drive support, see Device numbers on page 23.
When adding hard drives to the server, observe the following general guidelines:
60
Hardware options installation