Table of Contents
Advertisement
6.
Assemble the connector/cable harness pin openings to the alignment pegs on the DIMM guard.
7.
Install the plastic cover on the DIMM guard.
8.
Use a T-15 Torx screwdriver to install the DIMM guard, and then connect the cable to the system board.
9.
Install the access panel (Install the access panel on page 32).
10. Install the server in the rack.
11. Connect each power cord to the server.
12. Connect each power cord to the power source.
13. Power up the server (Power up the server on page 31).
Installing a FlexibleLOM option
Prerequisites
Before installing this option, be sure that you have the following:
128
Hardware options installation
Advertisement
Table of Contents
