Table of Contents
Advertisement
IMPORTANT: To enable SmartCache or CacheCade in a P-class type-p Smart Array controller, you must:
•
Connect the controller backup power cable to the controller backup power connector on the system or
riser board.
•
Connect the energy pack cable to the energy pack connector on the system board.
9.
Install the access panel (Install the access panel on page 32).
10. Install the server in the rack.
11. Connect each power cord to the server.
12. Connect each power cord to the power source.
13. Power up the server on page 31.
Hardware options installation
109
Advertisement
Table of Contents
