Table of Contents
Advertisement
Before installing this option, be sure you have the following:
•
The components included with the hardware option kit
•
Any expansion boards or controllers you plan to install
•
T-10 Torx screwdriver
•
T-15 Torx screwdriver
Procedure
1.
Power down the server (Power down the server on page 31).
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3.
Do one of the following:
a. Extend the server from the rack (Extend the server from the rack on page 31).
b. Remove the server from the rack (Remove the server from the rack on page 32).
4.
Remove the access panel (Remove the access panel on page 32).
5.
Remove the primary PCI riser cage (Remove the primary PCI riser cage on page 34).
6.
Use a T-10 Torx screwdriver to remove the slot 2 bracket from the primary riser cage.
7.
If installed, remove the low-profile riser cage.
Hardware options installation
91
Advertisement
Table of Contents
