Table of Contents
Advertisement
•
The components included with the hardware option kit
•
T-10 Torx screwdriver
Procedure
1.
Power down the server (Power down the server on page 31).
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3.
Do one of the following:
a. Extend the server from the rack (Extend the server from the rack on page 31).
b. Remove the server from the rack (Remove the server from the rack on page 32).
4.
Remove the access panel (Remove the access panel on page 32).
5.
Use a T-10 Torx screwdriver to remove the FlexibleLOM PCIe blank.
6.
Install the component:
a. Firmly seat the FlexibleLOM in the slot.
b. Tighten the thumbscrew.
Hardware options installation
129
Advertisement
Table of Contents
