Table of Contents
Advertisement
Item
Description
1
1
UID button/LED
2
Power On/Standby button and
system power LED
1
3
Health LED
1
4
NIC status LED
1
When all four LEDs described in this table flash simultaneously, a power fault has occurred.
2
Facility power is not present, power cord is not attached, no power supplies are installed, power supply failure has occurred, or the
power button cable is disconnected.
3
If the health LED indicates a degraded or critical state, review the system IML or use iLO to review the system health status.
Status
Solid blue = Activated
Flashing blue:
•
1 Hz = Remote management or firmware upgrade in
progress
•
4 Hz = iLO manual reboot sequence initiated
•
8 Hz = iLO manual reboot sequence in progress
Off = Deactivated
Solid green = System on
1
Flashing green = Performing power on sequence
Solid amber = System in standby
Off = No power present
Solid green = Normal
Flashing green = iLO is rebooting.
Flashing amber = System degraded
Flashing red = System critical
Solid green = Link to network
Flashing green = Network active
Off = No network activity
2
3
Component identification
9
Advertisement
Table of Contents
