HPE ProLiant DX360 Gen10 User Manual page 57

• The components included with the hardware option kit
• A T-10 Torx screwdriver might be needed to unlock the access panel.
Procedure
1. Observe the following alerts:
CAUTION: DIMMs and HPE Persistent Memory modules are keyed for proper alignment. Align notches on the
DIMM or HPE Persistent Memory module with the corresponding notches in the slot before installing the
component. Do not force the DIMM or HPE Persistent Memory module into the slot. When installed properly,
not all DIMMs or HPE Persistent Memory modules will face in the same direction.
CAUTION: Electrostatic discharge can damage electronic components. Be sure you are properly grounded
before beginning this procedure.
CAUTION: Failure to properly handle HPE Persistent Memory modules can damage the component and the
system board connector.
IMPORTANT: Hewlett Packard Enterprise recommends that you implement best practice configurations for
high availability (HA) such as clustered configurations.
2. Power down the server (Power down the server on page 31).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
a. Extend the server from the rack (Extend the server from the rack on page 31).
b. Remove the server from the rack (Remove the server from the rack on page 32).
5.
Place the server on a flat, level work surface.
6. Remove the access panel on page 32.
7. Open the DIMM slot latches.
8. Install the HPE Persistent Memory module.
Hardware options installation 57