Table of Contents
Advertisement
CAUTION: To prevent damage to electrical components, properly ground the server before beginning any
installation procedure. Improper grounding can cause electrostatic discharge.
2.
Back up all server data.
3.
Power down the server (Power down the server on page 31).
4.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5.
Do one of the following:
a. Extend the server from the rack (Extend the server from the rack on page 31).
b. Remove the server from the rack (Remove the server from the rack on page 32).
6.
Remove the access panel (Remove the access panel on page 32).
7.
If installed, remove the low profile riser cage.
8.
Install the secondary full-height PCI riser cage (Installing a secondary full-height PCI riser cage option on page
90).
9.
Remove the existing rear guide bracket from the card, if installed.
10. If installing a 3/4-length GPU, install the bracket supplied in the kit.
A T-15 Torx screwdriver is required to install the bracket.
Hardware options installation
99
Advertisement
Table of Contents
