Table of Contents
Advertisement
•
The components included with the hardware option kit.
•
T-10 and T-15 Torx screwdriver.
•
1 SFF drive, 2 uFF M.2 drives, or blanks.
Procedure
1.
Power down the server on page 31.
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3.
Do one of the following:
a. Extend the server from the rack on page 31.
b. Remove the server from the rack on page 32.
4.
Remove the access panel on page 32.
5.
Remove the primary PCI riser cage (Remove the primary PCI riser cage on page 34).
6.
If installed, remove any expansion boards installed in the riser board.
7.
Remove the riser board. Set aside for later use.
8.
If installed, remove the slot 2 bracket from the primary riser cage.
80
Hardware options installation
Advertisement
Table of Contents
