Installing The 4 Lff Display Port/Usb Module - HPE ProLiant DL360 User Manual

Installing the 4 LFF display port/USB module

Prerequisites
Before installing this option, be sure you have the following:
• The components included with the hardware option kit
• T-10 Torx screwdriver
Procedure
1. Power down the server (Power down the server on page 24).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack (Extend the server from the rack on page 24).
b. Remove the server from the rack (Remove the server from the rack on page 25).
4. Remove the access panel (Remove the access panel on page 25).
5. Using a Torx T-10 screwdriver, remove the 4 LFF display port/USB blank.
Installing the 4 LFF display port/USB module 99