Table of Contents
Advertisement
10. Connect any required internal or external cables to the expansion board.
11. Install the access panel (Install the access panel on page 32).
12. Install the server in the rack.
13. Connect each power cord to the server.
14. Connect each power cord to the power source.
15. Power up the server (Power up the server on page 31).
Installing an accelerator or GPU in the secondary riser cage
Use these instructions to install accelerator options, including GPUs, in the server.
Prerequisites
When installing a 3/4-length GPU, a low profile type -a controller must be installed.
Before installing this option, do the following:
Be sure that the power supplies support the installation of this option. For more information, see the Hewlett Packard
•
Enterprise Configurator website.
•
Be sure that you have the following items:
◦
The components included with the GPU enablement option kit
◦
T-15 Torx screwdriver
Procedure
1.
Observe the following alerts:
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
98
Hardware options installation
Advertisement
Table of Contents
