Table of Contents
Advertisement
12. Install the primary PCI riser cage.
13. Install the access panel (Install the access panel on page 32).
14. Install the server in the rack.
15. Connect each power cord to the server.
16. Connect each power cord to the power source.
17. Power up the server on page 31.
18. Install drives.
Installing a 2 SFF HPE Smart Carrier M.2 (SCM) drive cage
Prerequisites
Hewlett Packard Enterprise recommends installing the P816i-a controller to support more than eight SAS/SATA drives.
For more information, see Installing an HPE Smart Array P816i-a SR Gen10 Controller option on page 107.
Before installing this option, be sure you that have the following:
•
The components included with the hardware option kit.
•
T-10 Torx screwdriver.
Additional cables, as needed. For more information, see SFF cables on page 142.
•
•
2 SFF SAS/SATA drives, 4 uFF M.2 drives, or blanks.
For more information, contact a Hewlett Packard Enterprise authorized reseller.
Procedure
1.
Back up all server data.
2.
Power down the server on page 31.
3.
Remove all power:
Hardware options installation
73
Advertisement
Table of Contents
