Configuring An Hpe Smart Array Gen10 Controller; Energy Pack Options - HPE ProLiant ML110 Gen10 User Manual

• Server in rack mode: Install the server into the rack.
• Server in tower mode: Return the server to an upright position.
18. Connect all peripheral cables to the server.
19. Connect each power cord to the server.
20. Connect each power cord to the power source.

21. Configuring an HPE Smart Array Gen10 controller.

The installation is complete.
Configuring an HPE Smart Array Gen10 controller
Procedure
1. Power up the server.
2. If you are running the server in UEFI Boot Mode, select the boot options.
3. Update the drive firmware if it is not the latest revision.
4. (Optional) If running the server in Legacy Boot Mode, set the controller as the boot controller.
5. (Optional) If running the server in Legacy Boot Mode, change the controller boot order.
6. If the new controller is not the new boot device, install the device drivers.
7. If the controller firmware is not the latest version, use SPP to update it.
8. Use UEFI System Utilities or HPE Smart Storage Administrator (HPE SSA) to create arrays and logical drives.
See the following resources for more information:
• SPP – See the product documentation in the information library:
https://www.hpe.com/info/spp/docs
• UEFI System Utilities or HPE Smart Storage Administrator – See the following guide in the information library
(https://www.hpe.com/info/smartstorage-docs):
HPE Smart Array SR Gen10 Configuration Guide

Energy pack options

Hewlett Packard Enterprise offers two centralized backup power source options to back up write cache content on P-class
Smart Array controllers in case of an unplanned server power outage.
• HPE Smart Storage Battery
HPE Smart Storage Hybrid Capacitor
•
IMPORTANT: The HPE Smart Storage Hybrid Capacitor is only supported on Gen10 and later servers that
support the 96W HPE Smart Storage Battery.
Hardware options installation
77