Configuring An Hpe Smart Array Gen10 Controller - HPE ProLiant XL225n Gen10 Plus User Manual

14. Connect the following cables:
Smart Array controller SlimSAS cable
•
If you are installing a Smart Array P-class Gen10 controller, connect the storage controller backup power cable.
•
15. Install the secondary riser.
16. Install the air baffle.
17. Install the node cover.
18. Install the server.
19. Connect all peripheral cables to the server.
20. If removed, connect the tube set.
21. Power up the server.
22. Configure the HPE Smart Array Gen10 controller.
The installation is complete.

Configuring an HPE Smart Array Gen10 controller

Procedure
1. Power up the server.
2. If you are running the server in UEFI Boot Mode, select the boot options.
3. Update the drive firmware if it is not the latest revision.
4. (Optional) If running the server in Legacy Boot Mode, set the controller as the boot controller.
5. (Optional) If running the server in Legacy Boot Mode, change the controller boot order.
6. If the new controller is not the new boot device, install the device drivers.
Hardware options installation
63