Menu Mode - MIMAKI TS55-1800 Operation Manual

Chapter 1 Before Use

Menu mode

This machine has 4 modes. Each menu mode is described below.
NOT-READY mode
This is the mode in which the media has not been detected yet.
LOCAL mode
Local mode is the mode for the drawing preparation state.
All the keys are effective.
The machine can receive data from the computer.However, it does not perform printing.
Screen display in Local mode
Facial expression changes according to the condition of care of this machine. Use it as a guide for cleaning according to the
display condition. Using "Normal" or "Bad" as it is adversely affects the condition of the print head, which may cause a print
failure. Carry out maintenance as soon as possible.
Icon State
Good
Normal
Bad
Display current setting
number.
Displays the current head
height.
Displays the current heater
temperature.
The color of the icon above the
temperature display changes with
the current heater status.
Orange: Temperature rising
Green: Set temperature
reached
Gray: Heater off
This mode permits the following operations:
• Pressing the JOG keys to set up a drawing origin and drawing area.
• Pressing the [ENTER] key to check the remaining amount of ink, the description of the cartridge error, the
model name, the firmware version, and so on.

MENU mode

To set MENU mode, press the [FUNC1] key when this machine is in LOCAL mode.
In this mode, each function can be set.
REMOTE mode
This machine prints the data it receives.
1-16
• Station maintenance is used, cleaning around the head, wiper, and cap are not being
performed.
• Maintenance washing liquid cartridge is not set or there is no remaining amount.
• You are using the wiper beyond its life.
Local <Setup 1>
LOW
POST1
30 /40
30 /40
TEST PRINT TEST PRINT
MENU MENU
CLEANING CLEANING
[SEL] key Function key [FUNC1] ~ [FUNC3]
Press the [SEL] key to change the functions.
Change condition
Displayed when USB or
Ethernet cable is connected.
Display detected media width.
1620mm
POST2
30 /50
Displays detected ink levels
(approximate)
Displays the functions that
REMOTE REMOTE
have been set for the function
keys [FUNC1] – [FUNC3].