UNI-T MSO/UPO2000 Series Programming Manual page 40

Programming Manual
:TRIGger:SWEep {AUTO|NORMal|SINGle}
:TRIGger:SWEep?
Functional description：

This command is used to select trigger sweep mode.
AUTO: In no trigger condition, the internal will generate a trigger signal to force trigger.
NORMal: It will be generated only when the trigger condition is met.
SINGle: Generating single trigger when the trigger condition is met and then stop.
Return format：

Query returns trigger sweep mode {AUTO|NORMal|SINGle}.
For example：

:TRIGger:SWEep AUTO
:TRIGger:SWEep?
:TRIGger:LEVel:ASETup
Command format：

:TRIGger:LEVel:ASETup
Functional description：

This command is used to set tigger level at the vertical midpoint of signal amplitude.
For example：

:TRIG:LEVel:ASETup
:TRIGger:STATus?
Command format：

:TRIGger:STATus?
Functional description：

Query the current trigger status of the oscilloscope.
Return format：

Query returns STOP/ARMED/READY/TRIGED/AUTO/SCAN /RESET / REPLAY/ WAIT.
For example：

:TRIGger:STATus?
:TRIGger:LEVel
Command format：

:TRIGger:LEVel <level>
:TRIGger:LEVel?
Functional description：

This command is used to set trigger level value of normal trigger mode. Nuerical value of<level> must be
set after the conversion according to the amplitude volts/div scale and screen information.
Return format：

Query returns the <level> setting value, unit is V.
Instruments.uni-trend.com
Set channel 1 as AUTO trigger mode.
Query returns AUTO.
Set tigger level at the center.
Query returns AUTO.
MSO/UPO2000 Series
40 / 156