Settings For Operation And Operating Behavior; Setting The Short Commands For Weighing Applications - KERN FES 17K-4 Operating Instructions Manual

16 Settings for operation and operating behavior

Settings on the balance can be made via the menu by pressing the [MENU] key.
For navigation in the menu see chapter 8.2

16.1 Setting the short commands for weighing applications

Different weighing applications can be assigned to the function keys [F1] to [F3] as
short commands.
The FEJ weighing system supports only simple weighing, piece counting
and percent weighing. The weighing application coefficient multiplication
is not supported.
TFES_TFEJ-BA-e-2210
 Use the [F1] and [F2] keys to navigate to <6
ADMIN/ADJUST>.
 Press [F4] key to access the settings
 Use [F1] and [F2] keys to navigate to <61 SHORT
CUT MODE>.
 Press [F4] key to access the settings
 Use [F1] and [F2] keys to select desired function
key
611 F1 KEY [F1] key
612 F2 KEY [F2] key
613 F3 KEY [F3] key
 Press [F4] key to change assigned weighing
application
 Weighing application is located at the bottom right of
the display and starts flashing
 Use [F1] and [F2] keys to select desired weighing
application.
WEIG Simple weighing
COUN Piece counting
PCNT Percent weighing
MULT Coefficient multiplication
 Press [F4] key to confirm selection.
54