Figure 4-5 Removing And Installing A Battery Canister - Silicon Graphics TP9400 RAID Owner's Manual

4: Controller Enclosure Component Replacement Procedures
!
Handle
56
Caution: Be careful when removing the battery canister. It weighs approximately
14 lbs.
4. Remove the battery canister (Figure 4-5 on page 56).
Turn the captive screws counterclockwise, using a flat-blade screwdriver to loosen
the screws, if necessary. Use the handles to pull out the battery canister a few inches.
Grasp the sides of the battery with both hands and remove the canister.
Captive
Screws
Figure 4-5 Removing and Installing a Battery Canister
5. Install the new battery canister by sliding the it into the slot and tighten all captive
screws.
6. Replace the front cover by reversing the sequence in Figure 4-1 on page 50.
49174
007-4304-003