Reinstalling The Controller Enclosure - Silicon Graphics TP9400 RAID Owner's Manual

3: Controller Enclosure Operation

Reinstalling the Controller Enclosure

48
Use the following procedure to reinstall the controller enclosure into a rack.
1. Install the support rails in the rack. Refer to the procedure in the SGI TP9400 RAID
Installation and Upgrade Guide (108-0292-00X).
2. From the rear of the rack, slide the controller enclosure into the rack along the
support rails (Figure 3-9).
3. Fasten the rear and front mounting screws (Figure 3-9).
4. Replace the front cover (Figure 3-1).
5. Wearing antistatic protection, reinstall the components into the controller enclosure.
Refer to Chapter 4, "Controller Enclosure Component Replacement Procedures".
007-4304-003