Product Safety - Silicon Graphics TP9400 RAID Owner's Manual

B: SGI Field Engineering Compliance Statements

Product Safety

166
are designed to provide reasonable protection against such interference in an industrial
or office installation. However, there is no guarantee that the interference will not occur
in a particular installation. This system is not certified for home use.
You can determine whether your system is causing interference by turning it off. If the
interference stops, it was probably caused by the workstation or one of the peripherals.
To tell if the interference is caused by one of the peripherals, try disconnecting one
peripheral at a time to see if the interference stops. If it does, that peripheral is the cause
of the interference.
If your workstation does cause interference to radio or television reception, try to correct
the interference by using one or more of the following suggestions:
• Turn the television or radio antenna until the interference stops.
• Move the workstation to one side or the other of the radio or television.
• Move the system farther away from the radio or television.
• Plug the system into an outlet that is on a different circuit from the radio or
television. (Make certain the workstation and the radio or television are on circuits
controlled by different circuit breakers or fuses.)
This product has been tested and is listed, certified, or approved to the following product
safety standards:
• UL 1950
• CAN/CSA C22.2, No. 950-M89
• IEC 950
• EN 60 950
• Standard for Safety of Information Technology Equipment, including Electrical
Business Equipment, Class 1, SELV
007-4304-003