Table of Contents
Advertisement
MAX II Bolt Tension Monitor
stored until the MAX II's memory is full, which is a massive amount. If the user
attempts to store a grid in the MAX II when the memory is full, the MAX II will
respond with an error message indicating that the memory is unable to store the new
group.
The MAX II can store a great deal of data, considering there is a 4 GB internal SD
card on the board, as well as an external SD slot that will accept up to 64 GB cards.
It's not likely a user will get close to using all the memory in this gauge. Each
measurement stored can be consider a page of data, as it stores the measurement,
snapshot of the waveform, and all the settings of the MAX II at the time the
measurement was stored. The display views and quantities can be toggled for each
and every possible option of the MAX II, provided that the correct factors have been
entered into the gauge and are being used. To make this as clear as possible, the
Display Views (RF, RECT, and DIGITS) can be toggled with any stored
measurement. Additionally, the Quantities (Time, Elongation, Load, Stress, and
%Strain) can be toggled with any stored measurement. It's clear that the data
recordation of MAX II is an extremely powerful tool for purposes of documentation.
14.5 Creating a new Group
Important Note: This entire section is a step by step guide to successfully create a
group. The instructions must be used in the sequential order specified, as follows:
In order to eliminate too much redundancy with multiple pass of the same exact steps
for each of the group list items, the following procedure will be listed once below.
This process can be repeated for the name, note, number of bolts, number of reads,
starting bolt number, and the increment direction using the procedure below:
Creating a Group
163
GlobalTestSupply
www.
.com
Find Quality Products Online at:
sales@GlobalTestSupply.com
Advertisement
Table of Contents
