Table of Contents
Advertisement
MAX II Bolt Tension Monitor
The MAX II should be sent in for calibration by Dakota Ultrasonics, or other
authorized service representative, on a periodic basis to verify proper operation of the
instrument. Check in with your quality department to verify their duration requirement
for "Test & Measurement Equipment".
8.3 Creating a Group to Document Zero (Calibration) Data
A project folder named "CAL_ZERO_DATA" will automatically be created following
the completion of a "One Point", "Two Point", or "Auto" calibration option...if one
doesn't already exist. A group/log will automatically be created inside of the 'project
folder' with a 'date/time' stamp, each and every time the zero process has been
successfully completed. By default, the group/log will consist of 5 bolts and 10
measurements per bolt, allowing for additional calibration points, verification, and
recordation. The group log will contain the zero measurements, as well as the
diameter and calculated frequency of the transducer used.
The group/log files created will remain on the SD memory card until manually
deleted, and provide the user with additional documentation regarding when the zero
process was performed, as well as the outcome of the zero calibration process.
File Name (format): CALZERO211202_132519
Date(yr/month/day)_Time(hr/min/sec)
Note: This section applies to all the Zero/Calibration options (one point, two point,
auto).
Note: Refer to chapter 14.1 for instructions on how to Create, Open, Edit (group
name, note), Delete (a group/log), or Close (group) in a project folder.
Overview
49
GlobalTestSupply
www.
.com
Find Quality Products Online at:
sales@GlobalTestSupply.com
Advertisement
Table of Contents
